Wheelzbarrow WB-COMP-001 Manuál s instrukcemi stáhnout pdf

To tighten or loosen brake handle movement, tighten

or loosen nut on this screw.

BRAKE AND HITCH INFORMATION

Note: Brake shown in ON position.

™

ASSEMBLY INSTRUCTIONS

To release brake, pull handle towards you until handle

is away from brake-stop and then push handle down.

For replacement parts or warranties visit www.wheelzbarrow.com or call 855-838-2646

Attaching Hitch.

EASY COMFORT GRIP ASSEMBLY

Step 1: Place the left side of the tube handle (I) onto the left

wheelbarrow handle. Push it on partially.

Step 2: Slide the right side of the tube handle into left side

of tube handle. Now rotate right side of tube handle

on right wheelbarrow handle. Tap tube handle until

completely in place.

Step 3: Drill a 1/8” pilot hole into wheelbarrow handles through

holes at each end of tube handle. Make sure tube

handle is fully onto wheelbarrow handles.

Step 4: Screw wood screws (N) into 1/8” pilot holes.

REAR WHEEL ASSEMBLY

Step 1:

Slide cotter pin (R) through the inner hole of axle.

Step 2: Slide Washer (Q) onto axle until touching pin.

Step 3: Next slide the wheel on axle until it reaches washer.

Step 4: Finally slide on another washer and insert cotter pin

into outer hole.

Step 5: Repeat for the other side.

HARDWARE CONTENT

PACKAGING CONTENTS

A B C D

E F G H I

5 ½ in. Bolt x2

2 ¾ in. Bolt x2

Wooden Handle

x2 Riser x2 Wheel Guard x1 Tray x1

Axle Bracket x2

Axle x1 Frt Wheel x1

Back Wheel x2

Undercarriage x1 Easy Comfort

Grip x1

¾ in. Wood Screw x2

Nut x10

Large Washers x4

Spacer x2

Cotter Pins x4

2 ¼ in. Bolt x4

2 ¼ in. Bolt x2

1 2 3 4

ASSEMBLY INSTRUCTIONS 1
EXPLODED VIEW 2

Shrnutí obsahu

Strany 1 - ASSEMBLY INSTRUCTIONS

87To tighten or loosen brake handle movement, tighten or loosen nut on this screw.BRAKE AND HITCH INFORMATIONNote: Brake shown in ON position.™ASSEMBL

Strany 2 - EXPLODED VIEW

INSTRUCTIONSEXPLODED VIEWRead all instructions prior to assembly.Tools Required:• ½ in. wrench or ½ in deep-drive socket• Flat-head screwdriver• Ph

Strany 3

INSTRUCTIONSEXPLODED VIEWRead all instructions prior to assembly.Tools Required:• ½ in. wrench or ½ in deep-drive socket• Flat-head screwdriver• Ph

Strany 4

87To tighten or loosen brake handle movement, tighten or loosen nut on this screw.BRAKE AND HITCH INFORMATIONNote: Brake shown in ON position.™ASSEMBL

Komentáře k této Příručce

Žádné komentáře

Wheelzbarrow WB-COMP-001 Manuál s instrukcemi

Procházejte online nebo si stáhněte Manuál s instrukcemi pro ne Wheelzbarrow WB-COMP-001. Wheelzbarrow WB-COMP-001 Instructions / Assembly Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce